Dodge Caliber Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I need to replace the blend door actuator on my 2010 Dodge Caliber. The glove box comes out easy, but assessing the 3 bolts on the unit is almost impossible. Is there a way to remove the Chill Zone box above the glove box? It looks like it's part of the lower right dash panel, and after removing all the screws I see it's still looks to be attached somewhere. Any suggestions are welcome. Thanks.
 
1 - 1 of 1 Posts
Top